OWNER’S MANUAL INSTALLATION AND OPERATION INSTRUCTIONS CAST IRON SUBMERSIBLE SUMP PUMP MODEL: BASPC33V SKU#: 691-3204
If for any reason you have questions concerning your new Barracuda Pump, call us toll free at 1-844-251-7445. Carefully read and understand all of the warnings and installation instructions in this manual. Failure to follow these instructions could lead to serious bodily injury and/or property damage. Retain these instructions for future reference. This pump has been manufactured with your needs in mind.
For safety, the pump motor has an automatic resetting thermal protector that automatically will turn off the pump if it becomes too hot. Overuse of this feature will damage the pump and will void the warranty. Once the thermal protector detects that the pump has cooled to a safe temperature, it will allow the pump to operate normally. If the pump is plugged in, it may restart unexpectedly. DO NOT RUN THE PUMP DRY. The pump depends on water for cooling and lubrication.
INSTALLATION 1. For your own safety, turn off the electrical power at the service entrance to avoid any possible electrical shock hazards. 2. On a replacement installation, remove the existing pump from the sump by disconnecting the discharge pipe or hose from the old pump. Depending on how your old pump is installed, unscrew clamps and discard old corrugated hose, or unscrew galvanized or plastic pipe from pump discharge.
OPERATION 1. The pump’s shaft seal depends on water for lubrication. Do not operate the pump unless it is submerged in water; running it dry may damage the seal and void warranty. 2. If the pump overheats, an automatic-reset thermal protector cuts off the power and stops the motor before it can be damaged. The motor will automatically restart when it cools. If the protector trips repeatedly, unplug the pump, remove it from the sump, and check it for the cause of the difficulty.
REPLACEMENT PARTS To order replacement parts, call: 1-844-251-7445 # Description Qty Repair Kit # N/A 8 Impeller 1 9 Washer 1 10 Washer 1 1 Pump casing & Motor 1 2 Pump base 1 WSSPC-PBG Description Qty Repair Kit WSSPC-IMP 3 Gasket 1 4 Vertical Float Switch 1 11 Nut 1 5 Cable 1 12 Handle 1 N/A 6 Cable fitting 2 13 Screw 8 N/A 7 Bracket 1 16 Cable Gland 2 N/A 14 Screw 2 17 Packing 2 N/A 15 Screw 2 18 ADAPTER 1 BUSH-125-150 WSSPCV-RS 6
PERFORMANCE MODEL # BASPC33V MAX FLOW (GPM) @ 0’ 48 GPM FLOW @ HEAD 5’ 10’ 15’ 20’ 25’ 39 30 18 9 3 MAX HEAD (FT) 26 SPECIFICATIONS Power supply requirement ........................................................................................................ 115 V, 60 Hz Motor ........................................ 1/3 HP, Continuous Duty, Permanent Split Capacitor, Thermally Protected Amps .............................................................................................................
WARRANTY PERIOD - PRODUCTS: If, within the duration of product use by the original purchaser, this product proves to be defective due to materials or workmanship, the product shall be repaired or replaced at the Company’s option, subject to the terms and conditions set forth in this warranty statement. Proof of purchase is required for warranty consideration. In the absence of suitable proof of the purchase date, the effective period of this warranty is 12 months from the product’s date of manufacture.
