Safety Guidelines Carefully read, understand and Hollow all safety instructions in this manual. This is the safety alert symbol. When you see this symbol, look for ane of the following signal words, Indicates a hazardous situation which, if not avoided, will result in L ] death or serous injury, Indicates a hazardous situation which, it not avoided, could result in A caution death or serous injury, Indicates a hazardous situation which, if not avoided, could result in dinar or moderate injury.
Safety Information {continued} This pump motor is equipped with an automatic resetting thermal protector and may restart unexpectedly, Do not use this pump for potables drinking water. Use only in applications for which the pump is designed for. This pump is not Intended to pump water softener discharge {brine} or condensate. Pumping these liquids could cause damage to the pump and will void the warranty.
Installation 1. Thread the male cam-lock adapter (included) into the pump discharge, Connect the female cockamamie fitting (with hose, included) to the male adapter and secure. Extend the hose making sure there are no Kinks or tight bends in the hose or Thread the 3/4" garden hose adapter into the pump discharge. Attach a garden hose {sod separately) to the garden hose adapter. Extend the hose making sure there are na kinks or tight bends.
Maintenance Risk of electric shock. Always disconnect the power supply before P attempting to install, service or perform maintenance on the pump. All repairs must be made by an authorized service center. This submersible pump contains ol which may become pressurized and hot under normal operating conditions allow the pump to cool for 2-3 hours before servicing. 1. The pump motor is hermetically sealed in the housing and does not require any service.
Troubleshooting DANGER Risk of electric shock, Always disconnect the power supply before leg{Ra If the pump does not start OF POSSIBLE CAUSES Pump is not plugged in, switch or breaker is off attempting to install, service or perform maintenance on the pump. HOW TO CORER: Plug pump in or turn on switch/ breaker Check for blown fuses or tripped circuit breakers or tripped GUCCI outsets Replace fuse, reset breaker, reset Outlet Motor thermal protector tripped Allow pump to cool.
Replacement Parts Ref# Description BASRA 1 Power Cord 99008 2 Ol Fill Plug with C-ring 99056 3 Shaft Seal 99057 4 impeller 93065 5 Gasket 99187 6 Volute/Base 99185 7 intake Screen 99186 8 Han die 99051 9 25" Lay flat hose 99022 10 Hose Clamp 99183 11 Cam lock Fitting {male} 99020 12 Cam lock Fitting (female) 99021 13 314" Garden Hose Adapter 93001 S tore falls, replace entire pump Call 1-800-495-9278 for parts assistance 7
LIMITED WARRANTY FUTILITY PUMPS: Basra cuds Pumps warrants the products specified in this warranty to be free from defects in material or workmanship for two {2} years from date of purchase. During the time period and subject fo the terms and conditions. Barracuda Pumps wolf repair or replace t the original user or consumer any portion of this product which proves o he defective due ta materials or workmanship.
