Safety Guidelines Carefully read, understand and Hollow all safety instructions in this manual. This is the safety alert symbol. When you see this symbol, look for ane of the following signal words, Indicates a hazardous situation which, if not avoided, will result in L ] death or serous injury, Indicates a hazardous situation which, it not avoided, could result in A caution death or serous injury, Indicates a hazardous situation which, if not avoided, could result in dinar or moderate injury.
Safety Information {continued} This pump motor is equipped with an automatic resetting thermal protector and may restart unexpectedly, Do not use this pump for potables drinking water. Use only in applications for which the pump is designed for. This pump is not Intended to pump water softener discharge {brine} or condensate. Pumping these liquids could cause damage to the pump and will void the warranty.
Installation 1. Install the pump on a hard level surface in the water. I necessary, place bricks or patio blocks under the hump to raise it off the bosom. Do not place the pump directly in mud, sand or silt or on rocky surfaces as these materials can dog or cause damage to the pump. 2. Connect a hose to the pap discharge. Use either the supplied garden hose adapter or other hose fitting {sold separately). Choose the best size hose or pipe for your application.
Performances Height, pipe diameter restriction and hose length will reduce the pump output performance, it is recommended to use the same size or Larger pipe / hose as the pump discharge for optimum performance. The performances listed below were obtained by using pipe. The use of a garden hose will reduce the output depending on size ard length of has used. To keep friction as low as possible, hose must be 34" or larger. Use the shortest length of hose possible for your application.
Troubleshooting DANGER Risk of electric shock, Always disconnect the power supply before leg{Ra If the pump does not start OF POSSIBLE CAUSES Pump is not plugged in, switch or breaker is off attempting to install, service or perform maintenance on the pump. HOW TO CORER: Plug pump in or turn on switch/ breaker Check for blown fuses or tripped circuit breakers or tripped GUCCI outsets Replace fuse, reset breaker, reset Outlet Motor thermal protector tripped Allow pump to cool.
Replacement Parts BA1250 Power Cord Handle il Silt Plug wig-ring Shaft Seal impeller Gasket Pump Evaluate intake Screen 9 Garden Hiss Adapter it motor fails, replace entice pump For Parts or Assistance, please call 1-800-495-9278 7
LIMITED WARRANTY UTILITY PUMPS: Barracuda Pumps warrants the products specified in this warranty 1o be free from defects in material or workmanship for two {2) years from date of purchase. During the rite period and subject ta the trams and conditions, Barracuda Pumps will repair of replace to the original user or consumer any portion of this product which proves to be defective due to materials or workmanship.
