Specifications

Password – Enter a password.

Authentication Method – Select the authentication method supported by your network management software. E.g., SHA

Encryption Method – Select the encryption method supported by your network management software. E.g., AES

Allowed SNMP IP/Range – Enter the IP addresses or range from which the Barracuda SSL VPN should accept SNMP queries.

Click .Save Changes

Enable SNMP Traps

If you want your Barracuda SSL VPN to send SNMP traps to the network management system add the IP address:

Log into the .Administration interface

Open the page.ADVANCED > Administration

In the section, add the IP address of the network management system.SNMP Traps

Click .Save Changes

Maintenance

The following article section describes in detailed steps how to configure and restore backups of the Barracuda SSL VPN configuration and

explains the procedure of firmware updates.

In this Section

How to Configure Automated Backups

Restore from Backups

Update Firmware

How to Update the Firmware in a High Availability Cluster

How to Configure Automated Backups

It is recommended to always have working backups of your appliance. In case of a

hardware failure or system misconfiguration the backup files can be used to quickly

restore the appliance to working order. The administrator can configure how many

backups are saved to a SMB share, FTP or FTPS server.

Restore from Backups

Configure Automatic Backups

Log into the .Administrative web interface

Open the page.BASIC > Backups

In the section, complete the following tasks:Automated Backups

Configure the remote server where the backups are stored. You can choose between SMB and FTP servers. You can verify the

connection to the remote storage by clicking .Test Backup Server

Select the type of backups you want to create and set the time.

Click .Save Changes

Restore from Backups

You can restore the Barracuda SSL VPN from a backup file you previously created. If

you did a complete backup or just a backup up of the Appliance or SSL VPN

configuration you can do a full or partial restore.

Complete Restore for the Barracuda SSL VPN

How to Configure Automated

Backups

Open the page.BASIC > Backups

In the section, select the backup file source. Select to restore from a network share, or local ifRestore Backups Restore From: smb

you have the backup files on you local computer.

Click . Browse