User`s guide

3.
c.
4.
1.
2.
3.
4.
Click the tab and change to specify the Wi-Fi subnets.General Source
At the top of the rule editor window, click .Save
Step 5. Verify the Order of the Rules in the Rule Set
Because rules are processed from top to bottom in the rule set, arrange your rules in the correct order. Also verify that your rules are placed
above the BLOCKALL rule; otherwise, the rules are blocked.
After adjusting the order of rules in the rule set, click .Save Changes
How to Configure a VLAN
You can use VLANs to simulate several LANs on one physical network interface (but only one MAC address). The physical interface behaves as
if it were several interfaces, and the switch behaves as if it were multiple switches. VLANs let multiple virtual networks share switches, cables, and
routers. All VLANs created on a host interface share the bandwidth of the physical interface. However, you can configure bandwidth policies
(QoS) to specify how much bandwidth an interface can use.
In this article:
Create a Virtual Interface
Next Steps
Create a Virtual Interface
To add a VLAN:
Go to the page. NETWORK > IP Configuration
In the section, add an entry for the VLAN. In the VLAN configuration, you can only select a hostVirtual Interface Configuration
interface that is capable of supporting VLANs and connected to a correctly configured VLAN switch.
Click .Save Changes
At the top of the page, click on the warning message to execute the new network configuration. It can take up to two minutes for the
settings to be applied.
The VLAN interface then appears in the section. VLAN interface names are displayed in this format:Network Interface Configuration
p< > < >port number . vlan id
You must have a properly configured 802.1q-capable switch to support VLANs.