User`s guide

7.
1.
2.
3.
4.
5.
6.
1.
Step 2. Configure Phase 2
To configure Phase 2:
In the left menu, right-click the entry (that you might have renamed to e.g. ) and select .Gateway Phase 1 New Phase 2
If you want to rename the entry that was created as a child of the entry, right-click it and select . For example,Tunnel Gateway Rename
you can rename it as .Phase 2
Click the entry and then click the tab.Tunnel IPSec
In the section, select as the .Addresses Subnet address Address type
In the remaining fields of the section, enter the network settings that were configured for the VPN service.Addresses
In the section, select the settings that are used by the VPN service.ESP
Step 3. Disable Mode Config
To disable the Mode Config:
Go tab , and verify that that the check box is cleared. Mode Config is ato Gateway > Advanced > Advanced features Mode Config
feature of certain routers to remotely configure the client's IP , which is not required in this setup.addressing