Specifications

8. Repeat steps 2 - 6 with the two empty car-

tridges supplied with your EASYpure UV/UF,

placing them in the center and left-hand

positions.

9. Close the cartridge access door. Remove the

0.2 micron filter and bell assembly.

10. Sanitize, install new cartridges and rinse

according to the instructions for Initial Saniti-

zation and Cartridge Installation in the Initial

Operation section.

General Cleaning Instructions

Wipe exterior surfaces with lightly dampened cloth

containing mild soap solution.

0.2 Micron Filter Replacement

Replace the 0.2 micron filter whenever any of the follow-

ing conditions occur: every 30 days, the product water

flow rate is reduced or bacteria break through. The 0.2

micron filter is shipped assembled with a bell. To replace

the 0.2 micron filter assembly:

1. Remove the old 0.2 micron filter assembly by

turning it counterclockwise until it is free from

the Luer fitting.

2. Remove the new 0.2 micron filter assembly

from its bag and insert it into the Luer fitting.

Gently turn it clockwise until it is fully seated in

the Luer fitting.

3. Rinse 10-15 liters of water through the filter to

drain prior to using the product water.

MAINTENANCE AND SERVICING

Note

Used cartridges may be recycled. See

P.U.R.E. information packed with new

cartridges.

Caution

Do not overtighten the 0.2 micron filter

assembly onto the Luer fitting or use

excessive force in seating it. The filter

and/or Luer fitting can be damaged by

overtightening or excessive force.

Note

If a newly installed 0.2 micron filter

clogs rapidly after installation, the

EASYpure UV/UF may need to be

sanitized to remove bacterial contami-

nants. See System Sanitization.