Specifications

1. Press the START/STOP button to start. The

EASYpure UV/UF’s pump will begin to run and

the Purity meter will display the resistivity of the

water in megohm-cm.

2. Allow the water’s resistivity to rise to the desired

purity before drawing off water.

3. The system should be left on during the work

day. (See use of Standby mode.)

Water Draw Off

1. Remove the protective cap from the filter bell.

2. Depress the draw-off lever.

3. When draw off is complete, lift the draw-off lever

and replace the protective cap on the filter bell.

Use of Standby Mode

At the end of the work day, press the Standby switch on the

front of the EASYpure UV/UF to place the unit in Standby

mode for the night.

Normal Operation

Note

On initial start-up, the purity meter may

display “ERR”. This is caused by air in

the cell and should be replaced by a

resistivity reading almost immediately.

If “ERR” does not go out after the

pump has run for a minute or if it

appears any time while the EASYpure

UV/UF is in operation, refer to the

Problem Solving section of this

manual.

Note

For low organic and pyrogen applica-

tions, draw off 50 to 100 ml of water

from system and discard prior to

drawing water for each use.

Note

Do not turn off the EASYpure UV/UF

during non-work hours. Doing so will

allow bacterial growth and other

contamination of the water in the

system. As a result, the system will

require a lengthy rinse-up period at the

beginning of the work day to achieve

high-quality product water.