Specifications

Run Mode

Since not all qualities of permissible feedwater will reach

maximum resistivity after one pass through the unit’s

cartridges (especially as the cartridges near exhaustion),

the EASYpure UV/UF has two operational modes.

In the run mode, the UV lamp shines continuously and the

pump continuously recirculates water through the car-

tridges, the UV chamber and the ultrafilter. It is recom-

mended that the EASYpure UV/UF be left in the run mode

during the day. In the run mode, the purity meter display

indicates the resistivity of the water available for draw off.

Standby Mode

In Standby Mode, the UV lamp shines and the pump runs

for ten minutes out of every hour (i.e 10 minutes on, 50

minutes off). This will allow the unit to produce high quality

water quickly upon being placed in the run mode. It is

recommended that the EASYpure UV/UF be placed in the

Standby mode during non-work hours.

Automatic Flush

In both the run and Standby modes, the EASYpure UV/UF

will initiate a one minute automatic flush of the ultrafilter

once every twenty-four hours of operation. This prevents

bacterial buildup on the ultrafilter. A solid-state timer in the

EASYpure UV/UF counts the hours power is applied to the

unit. When the timer reaches twenty-four hours, the

EASYpure UV/UF initiates a one minute flush, the Auto-

matic Flush LED is illuminated. The timer will reset to zero

when the one minute automatic flush is completed.

Operational Modes

Note

Do not turn off the EASYpure UV/UF

during non-work hours. Doing so will

allow bacterial growth and other

contamination of the water in the

system. As a result, the system will

require a lengthy rinse-up period at the

beginning of the work day to achieve

high-quality product water.