Specifications

12
Wall Mounting (Optional)
Install the optional wall bracket on the wall in a location that
is accessible to water, electricity and an atmospherically
vented drain, and that is convenient to use. A minimum of 4
fasteners must be used.
1. Remove the four feet from the EASYpure UV/UF
and retain the screws.
2. Place the EASYpure UV/UF on the wall bracket
swivel base so the screw holes where the feet
were attached line up with the holes in the wall
bracket. There are guides on the wall bracket
that will mate with the EASYpure UV/UF. See
Figure 7.
3. Reinstall the four screws removed in step 1
through the bottom of the wall bracket and into
the EASYpure UV/UF.
Water Connections
Feedwater Connection
1. Locate the length of 3/8” O.D. tubing provided
with a quick disconnect insert on one end and a
3/8” O.D. X 1/4 NPT tubing adapter on the other.
2. Install the tubing adapter onto your incoming
water line. We recommend a customer supplied
shut off valve be installed in your feed water line.
Do not connect the feedwater to your EASYpure
UV/UF until you are told to do so. (See Initial
Operation.)
INSTALLATION
Note
The outlet of a gravity feed storage
reservoir must be above or at the
same level as the inlet of the
EASYpure UV/UF.
Caution
Wall composition, condition and con-
struction, as well as fastener type, must
be considered when mounting this unit.
The mounting surface and fasteners
selected must be capable of supporting
a minimum of 120 lbs. Inadequate
support and/or fasteners may result in
damage to mounting surface and/or
equipment. If you are unsure of mount-
ing surface composition, condition and
construction or correct fasteners,
consult your building maintenance
group or contractor.