Specifications

10
you. Viewed this way, the product connector is
the one on the left. The reject connector is the
one on the right. (See Figure 5) Remove the nut,
stainless steel grab-ring, backup ring and o-ring
from each of the ultrafilter connections and
discard.
5. The three pieces of tubing that you disconnected
from the “T” in step 2 are the Feed, Reject and
Product lines for the ultrafilter. The Reject and
Product tubing nuts are labeled; the unlabeled
one is the Feed line. Connect the ultrafilter Feed,
Reject and Product lines to the appropriate
connectors on the ultrafilter, identified in step 4.
Ensure that the stainless-steel grab ring, backup
ring and o-ring from each connector remain on
each piece of tubing. Tighten the connectors by
hand; do not use a wrench.
6. Press the ultrafilter into the ultrafilter securing
clips inside the EASYpure UV/UF case. Ensure
that you maintain the proper orientation of the
ultrafilter during installation, with the feed con-
nection on the bottom and the reject and product
connections on the top.
INSTALLATION
Figure 5: Ultrafilter Connections Figure 6: Ultrafilter Orientation and UV Chamber Location
Product
Reject
Feed
Black Plasitc Cap on
UV Chamber
Proper Installation of
Ultrafilter