Instruction manual

EASYpure II RF 5-1Thermo Scientific
Section 5 Installation
1. Place the EASYpure II RF on a bench top convenient to your work
area, noting the Clearance Requirements. If wall mounting is required
contact Technical Services.
2. Using 1/2" I.D. tubing and tubing connectors (user supplied), connect
the overflow drain tubing (lower left corner of the rear of the unit) to
an atmospherically vented sink or floor drain. If an atmospherically
vented sink or floor drain is not accessible, a bucket or other container
may be placed on the floor beneath the EASYpure II RF’s location and
emptied when full.
Warning Do not place EASYpure II RF directly over equipment requiring
electrical service. Routine maintenance of this unit may involve water
spillage and subsequent electrical shock hazard if improperly located.
s
Warning Do not use in the presence of flammable or combustible
materials; fire or explosion may result. This device contains components
which may ignite such materials.
Warning This device is to be used with water feeds only. Sanitizing/
cleaning agents must be used in compliance with instructions in this
manual. Failure to comply could result in explosion and personal injury.
s
Figure 5-1. Front View Figure 5-2. Back View
Locating the Unit