Specifications

Power Connections

(See Fig. 8)

1. The power connection is located on the left side

of the unit, in the upper back corner.

2. Determine which power cord you need (this will

be based on your country and outlets available

in your lab). Both North American and

European power cords are provided with the

unit.

3. Remove the fuse holder, install the fuses includ-

ed with the power cord to be used, and reinstall

holder.

4. Verify power switch is turned off and attach

receptacle end of power cord into the power

socket.

5. Plug other end of power cord into facility power.

Air Purge

1. If the optional remote dispenser is connected to

the EASYpure II LF, place the draw-off trigger

into the locked position by depressing the button

on the right side of the dispenser at the same

time as the trigger is depressed.

If there is no remote dispenser being utilized,

ensure that the hose barb is attached to the

draw-off valve fitting and depress the draw-off

valve lever to open the draw-off valve.

2. Place a suitable container under the opened

valve to collect water while purging air.

3. Connect the water supply to the EASYpure II LF

and open the customer supplied shut-off valve.

4. Turn the power switch on.

INSTALLATION

Warning

To avoid electrical shock, always use a

properly grounded electrical outlet of

correct voltage and current handling

capacity.

Caution

Do not allow EASYpure II LF to operate

unless water is available to unit.