Specifications

Standby

In Standby (“SbY”) Mode, the pump will restart for ten min-

utes out of every hour (i.e 50 minutes off, 10 minutes on),

during which time the display reads “rEC” which indicates

recirculation. Every fourth time that the pump turns on, the

UV lamp will also turn on for 10 minutes. This will allow the

unit to produce high quality water quickly upon being placed

in the Run Mode and prolong the life of the UV lamp. It is

recommended that the EASYpure II UV/UF be placed in the

Standby Mode during non-work hours. At the end of the

work day, press the STANDBY switch to place the unit in

Standby mode. “SbY” will appear on the display.

FLUSH

Manual Flush

Pressing the Flush switch once will initiate a one minute

flush of the ultrafilter. During this one minute flush, water is

sent to drain through the drain tubing and the display will

show FL1. Pressing the Flush switch twice will initiate a five

minute flush of the ultrafilter. During this five minute flush

the display will count down FL5, FL4, FL3, etc. After the

timed flush has ended, the EASYpure II UV/UF will return to

the mode (“IdL”, Run or Standby) it was in when you initiat-

ed the flush. We recommend that you initiate a one minute

manual flush when starting up the EASYpure II UV/UF prior

to your day’s work.

Automatic Flush

In both the Run and Standby Modes, the EASYpure II

UV/UF will initiate a one minute automatic flush of the ultra-

filter once every twenty-four hours of operation. This pre-

vents bacterial buildup on the ultrafilter. A microcontroller

timer in the EASYpure II UV/UF counts the hours power is

applied to the unit. When the timer reaches twenty-four

hours, the EASYpure II UV/UF initiates a one minute flush if

in the Run Mode. If the unit was in Standby, the automatic

flush will occur immediately after the START/STOP switch is

pressed and Run Mode entered. The timer will reset to

zero when the one minute automatic flush is completed.

Idle Mode (“IdL”)

“IdL” indicates the unit is powered and waiting to be placed

in Run, Standby or Flush Mode.

ONTROLS AND NORMAL

OPERATION

Note

If the unit is in Standby and power to

the unit is turned off or lost, the unit

will return to Standby once power is

restored.