Specifications

INSTALLATION
13
Caution
Do not touch the glass portion of the
UV lamp. We recommend that you
wear lint-free gloves when handling the
lamp. The glass portion must be free of
fingerprints, perspiration, etc. Even a
single fingerprint will reduce the effec-
tiveness of the lamp. If you accidentally
touch the glass portion of the lamp,
clean the lamp with a lint-free cloth;
use isopropyl alcohol if required.
Caution
Do not rotate the metal cover as this
will loosen the water tight seal and
thus damage the UV lamp.
Note
If UV lamp is not installed properly
an “Er3” message will appear for 15
seconds of every minute.
Black plastic cover
Receptacle
UV lamp
UV chamber
Component Installation
UV Lamp Installation (See Fig. 5)
Before you mount the EASYpure II UV/UF, install the UV
lamp as follows:
1. Remove the screws securing the EASYpure II
UV/UF top cover.
2. Remove the top cover by lifting straight up.
3. Locate the UV oxidation chamber and pull the
top black plastic cover off. Do not pull on the
cable.
4. Remove the lamp from its container. DO NOT
TOUCH THE GLASS PORTION OF THE
LAMP. It is recommended that lint free gloves
be worn when handling the lamp. The glass
portion must be free of fingerprints, perspira-
tion, etc. Even a light coating of perspiration
will reduce the effectiveness of the lamp.
5. Clean the lamp with isopropyl alcohol and a lint
free cloth.
6. Carefully insert and hold the UV lamp partially
into the UV chamber.
Figure 5 UV Lamp Installation
Warning
This unit is equipped with an
ultraviolet lamp. Ultraviolet radiation
is harmful to the eyes and skin. Do
not observe the lamp directly.
Note
The UV lamp contains mercury. If
broken or no longer needed, do not
dispose of the UV lamp in the trash.
Recycle or dispose of the UV lamp as
hazardous waste.