Specifications

Water Connection Details

Push-to-Connect Fitting Tubing

Installation

The following instructions will apply when you need to

install the ultrafilter and to attach a piece of tubing to your

EASYpure II UV/UF during installation, unless otherwise

noted in the installation instructions. To make tubing con-

nections:

1. Make sure the tubing is cut off reasonably

square and that no plastic burrs or ridges

are present.

2. Mark from end of tube an insertion length of

11/16”.

3. Wet the tube end with water and insert the tube

straight into the fitting until it bottoms out on the

interior shoulder and the insertion mark is no

longer visible.

Push-to-Connect Fitting Tubing Removal

(Refer to Fig. 1 & 2)

1. Using the tool provided (AYX23), push the collet

toward the body while pulling on the tubing to

release the tube.

Installation

COLLET

TUBING

TYPICAL

FITTING

11/16"

Insertion

Length

Figure 1

Tubing Installation

Note

For easier insertion, wet the end of

the tubing with water.

Note

Figure 1 & 2 will be used at the ultra-

filter, as well as the connection at the

atmospheric drain, and the optional

remote dispenser.

Figure 2

Tubing Removal