Instruction manual

3-4 Type II Water System Thermo Scientific
Section 3
Installation
The following instructions will apply when you need to attach a piece of
tubing to your Barnstead TII during installation, unless otherwise noted in
the installation instructions. To make tubing connections:
1. Make sure the tubing is cut off reasonably square and that no plastic
burrs or ridges are present.
2. Mark from end of tube an insertion length of 3/4” (1.9 cm).
3. Wet the tube end with water and insert the tube straight into the
fitting until it bottoms out on the interior shoulder and the insertion
mark is no longer visible.
1. Using the tool provided (AYX23), push the collet toward the body
while pulling on the tubing to release the tube, as shown in Figure 3-
15.
Push-to-Connect
Fitting Tubing Install
COLLET
TUBING
*
*
TYPICAL
FITTING
Figure 3-14. Push-To-Connect Fitting Tubing Installation
Push-To-Connect
Tubing Removal
Figure 3-15. Push-To-Connect Tubing Removal