Instruction manual

8. Tube removal tool (AYX23): shown in Figure 3-5.

9. Wall Bracket - Unit (BC1190X12)

10. Wall Bracket -Remote Display (BC1190X10), shown in Figure 3-6.

11. Display Cable (WH1403X4)

12. Blank Display (DL1190X18), shown in Figure 3-6.

13. RO Membrane (FL1265X1) - Model D14041 has two membranes.

14. Quick Reference Guide (LTX112)

Note Also required for installation (purchased separately):

1. A storage reservoir. If a Barnstead TII storage reservoir (D14061,

D14062, D14063, D14064, D14071, D14072, D14073 or D14074)

is also purchased, see contents in separate box.

2. Start-up kit (D502138). Contains the Barnstead TII DI Cartridge Pack

(with 0.2 μM final filter) (D502137), 1 μM Pre-filter (D502113),

MPS Cartridge (D502114), Extruded Carbon Cartridge (D502115),

and Cartridge Block (BK1404X2).

3. Customer-supplied fasteners to mount unit and remote display.

4. Household bleach for the cleaning process.

Locate storage reservoir approximately 2 - 5 ft. (1.52 m) from the

Barnstead TII for electrical connections.

Refer to the Barnstead TII storage reservoir manual or customer-supplied

reservoir manual for mounting instructions. The outlet of the Barnstead

TII storage reservoir must be above or at the same level as the inlet of the

Barnstead TII.

3-2 Type II Water System Thermo Scientific

Section 3

Installation

Unpacking

(continued)

Figure 3-6. Control Panel Accessories:

(Left) Blank Display (DL1190X18), (Right) Control Panel Wall Mount Bracket

Locating Unit