User Guide

7
A
A
S
S
S
S
E
E
M
M
B
B
L
L
Y
Y
G
G
U
U
I
I
D
D
E
E
Mounting the Front Sight
1.) Attach the front sight bracket by attaching it to the bow
limb housing using the two lock washers and socket
head screws provided.
2.) Insert the sight pin into bracket by unscrewing the
threaded lock nut from the pin and inserting it through
the side of the front sight so that the point of the pin is
in the center of the front sight.
3.) Replace threaded lock nut on sight pin and tighten.
Install the second pin in the same manner facing first
pin.
Mounting the Rear Peep Sight
1.) Slide the rear peep sight onto the attached dovetail with
setscrew facing the front of bow.
See figure 1
2.) Tighten the setscrew when the
peep is in the proper eye relief
position with the hex key
provided.
Installing an Optional Scope
The recommended crossbow scope is a Barnett Red Dot Sight.
1.) Remove peep sight from the scope rail.
2.) Position your scope by moving it forward or backward
until the proper eye relief is found. This is typically three
to four inches from your eye to the eye-piece when you
are holding the crossbow in a shooting position.
3.) After scope installed you may remove the front sight
bracket and pins.
Important: Be sure to tighten scope mount rings before
shooting crossbow.
Stock Extension
The RC-150 model has a stock extension included. To make
adjustments, loosen front nuts, pull extension back exposing
rear nuts, adjust to desired position using back nuts. Then
secure tightly with front nuts.
Fig. 1