User Guide

WARNING: NEVER USE YOUR CRANK DEVICE TO UN-COCK/
UN-LOAD STRING FROM TRIGGER
CRANK OPERATION
NOTE: TO DISENGAGE THE RATCHET FEATURE
PLACE TOGGLE SWITCH INTO THE BACK AND
DOWN POSITION. THIS WILL ALLOW CRANK
HANDLE TO ROTATE IN TWO DIRECTIONS.
NOTE: WHEN CRANKING THE STRING BACK,
PLACE THE TOGGLE SWITCH IN THE FORWARD
POSITION TO ACTIVATE THE RATCHETING FEA-
TURE. THIS WILL ALLOW CRANK HANDLE TO
ROTATE IN ONE DIRECTION.
WITH CRANK COCKING DEVICE (CCD) INSTALLED, YOU ARE READY TO USE:
1. Place the Toggle Switch in the back and down position.
2. Attach String Puller Assembly to string by inserting crossbow string into hooks.
3. Install the Crank Handle to either right or left side (depending on your dominate hand) and tighten Thumb
Screw.
4. Place Toggle Switch in the forward position to engage Right Side String Spool and turn Crank Handle clock-
wise. Note: you should hear a ratcheting sound and the Crank Handle should not turn counter clockwise.
5. Turn the Crank Handle until the crossbow string engages the trigger and safety mechanism.
6. While holding the Crank Handle securely, place the Toggle Switch into the back and down position. Turn
Crank Handle slowly counter clockwise until the trigger mechanism stops the crossbows string.
7. Place String Puller Assembly on bottom dovetail of scope mount to keep out of the way when shooting.