QUAD 400 CRANK COCKING DEVICE ASSEMBLY, INSTALLATION & OPERATION GUIDE
SAFETY GUIDELINES DO NOT TURN HANDLE BACKWARDS WHILE DRAWING THE BOW!! THIS WILL DAMAGE THE ROPE. The Latch mechanism should always be engaged when cocking the crossbow. An audible clicking sound should be present while turning the handle in a forward rotation. If this clicking sound is not present, place the safety in the engaged position. UN-COCKING THE CROSSBOW - DO NOT un-cock the crossbow with the Crank Cocking Device. This could cause bodily injury or damage to your crossbow.
THIS PAGE INTENTIONALLY LEFT BLANK
CRANK ASSEMBLY STEP 1 NOTE: ANCHORS WILL GO OVER STRING FROM SPOOLS TO CONTAIN THEM IN THE GROOVE 2. RIGHT SIDE STRING SPOOL (THE SPOOL WITH NOTCHES) 4. 1/4-20 SOCKET HEAD CAP SCREW 5. 1/8” PINS (4 PCS) 3. THUMB SCREW 6. CRANK HANDLE ASSEMBLY 1. LEFT SIDE STRING SPOOL Insert 1/8” pins (5) into right side string spool, then insert right side string spool into middle stock hole. (Note: You may apply a white lithium grease to the spool bushing to reduce friction.
CRANK ASSEMBLY STEP 2 STRING 7. RIGHT SIDE STRING ANCHOR 9. FINISH CAP (RIGHT SIDE) STRING 8. LEFT SIDE STRING ANCHOR 10. FINISH CAP (LEFT SIDE) 11. #10 -24X1” SOCKET HEAD CAP SCREW Insert right side string anchor (7) into front stock hole. Insert left side string anchor (8) into front stock hole. Insert #10-24X1” socket head cap screw (11) into left string anchor and tighten. Press Finish Caps (9 & 10) into right and left anchor holes.
CRANK ASSEMBLY STEP 3 CONNECT STRING PULLER ASSEMBLY USING DOVETAIL UNDER FRONT OF SCOPE MOUNT WHEN NOT IN USE. 15. CATCH COVER 12. SPOOL CATCH 14. #4-40 SOCKET HEAD CAP SCREWS (2) 13. CATCH PLATE Insert spool catch (12) into the right side back hole. Insert catch plate (13) into left side back hole. Insert #440 socket head cap screws (14) through catch plate and thread into spool catch. Press catch cover (15) into hole when completed.
WARNING: NEVER USE YOUR CRANK DEVICE TO UN-COCK/ UN-LOAD STRING FROM TRIGGER CRANK OPERATION NOTE: TO DISENGAGE THE RATCHET FEATURE PLACE TOGGLE SWITCH INTO THE BACK AND DOWN POSITION. THIS WILL ALLOW CRANK HANDLE TO ROTATE IN TWO DIRECTIONS. NOTE: WHEN CRANKING THE STRING BACK, PLACE THE TOGGLE SWITCH IN THE FORWARD POSITION TO ACTIVATE THE RATCHETING FEATURE. THIS WILL ALLOW CRANK HANDLE TO ROTATE IN ONE DIRECTION. WITH CRANK COCKING DEVICE (CCD) INSTALLED, YOU ARE READY TO USE: 1.
BARNETT INTERNATIONAL INC. USA 13447 BYRD DRIVE ODESSA, FL 33556 PHONE: 800-237-4507 FAX: 813-920-5400 BARNETT INTERNATIONAL, INC. UK DIVISION DOCK MEADOW DRIVE, LANESFIELD WOLVERHAMPTON, WEST MIDLANDS ENGLAND WV46UD PHONE: 01902405121 FAX: 01902409447 Warranty registration card (below) must be mailed within 10 days of purchase to validate the warranty.
