User Guide

ASSEMBLY

Panzer V

Installing Prod

1. Open prod latch on bottom side of stock.

2. Instert stock through strung prod with string facing

upward.

3. Rotate prod where the string lays on top of the flight

track,insert prod into the opening the prod latch

provided.

4. Close prod latch and insert nut into recess on opposite

side. Insert screw through prod latch and tighten

5. Slide pressure pad in between the nose bolt and the

prod. Tighten until prod is firmly seated.

IMPORTANT Do not over tighten the nose bolt. When the

screw makes contact with the pressure plate tighten only

enough to prevent unwanted movement. Over tightening

will crush the fiberglass and permanently damage the

prod/limb.

Attaching Foot Stirrup

1. Line up mounting holes underneath the nose of the

crossbow with the foot stirrup. Attach using hex head

bolts supplied in hardware kit.

Stringing the crossbow

Important do not attempt to string your crossbow by

exerting downward pressure on the stock or prod! This

may cause breakage and will void your warranty. Use

only the cable stringer method. Make sure the nockends

are firmly seated on prod

1. Place loops of the black steel cable stringer over the

prod nockends, just as you would with a bowstring.

Some hand tension may be kept on cable stringer to

keep it properly seated.

See Figure 1

2. Cock the crossbow, using the foot

stirrup for stability. The safety is now

automatically engaged.

3. Insert bowstring loops through the

loops of cable stringer and seat over

nock ends.

. 1