Installation Guide

Chapter 2 Installation
36 BarMate Installation Guide
4 Place the SRD on mounted bracket; observe orientation
of SRD and mounting bracket.
CAUTION:
Snapping an SRD into its mounting bracket powers on
the device. Before powering the SRDs, the SAM must be
calibrated with one SRD. After calibrating the SAM, then
snap all SRDs into their brackets. Calibration is an open
question at the moment – TBC!!!
Figure 23: Connecting the SRD to its mounting bracket.
Magnet at top of
bracket
Glides – for tie
wraps
Disconnect Slot
Extenders
fit in
bracket
Bracket
Mount