Installation Guide

Chapter 2 Installation
34 BarMate Installation Guide
To install and mount the SRD
1 Identify a mounting surface that allows the SRD to be
mounted in a vertical orientation.
Figure 20: SRD and mounting plate.
2 Attach to surface identified in site survey:
• If an adhesive is used, attach adhesive to bottom of SRD
Mounting Bracket.
• If Tie-Wraps are used, wrap SRD mounting plate with tie
wrap, inserting tie wrap through plate glides.
• If attaching SRD to a round pole, insert screw to screw
hole in middle of SRD mounting bracket. The screw will
prevent the SRD from rotating around the pole.
►
Note: If the adhesive is used for attachment, verify the
surface is clean and dry.
SRD mounting
bracket orientation.
The SRD attaches to
bracket with the LED
on top, so that the
internal antenna is
vertical.
LED is on top