Installation Guide

Chapter 2 Installation
BarMate Installation Guide
31
To connect SAM to Antenna Array, COM Antenna, and
Solar Panel
1 For the antenna array, use an RG58 coaxial cable and
connect one end to the SMA port on one of the RX
antennas. Connect the other end to one of the RX
connectors on bottom of the SAM. Repeat this for each
of the four antennas in the array.
2 For the COM antenna, use a coaxial cable and connect
one end to the N-Female connector on the COM
antenna. Connect the other end to the COM (TNC) port
on bottom of the SAM. The TNC port is located in the
middle of the four RX ports.
Figure 17: Antenna connections on the bottom of the SAM.