Manualshelf

Installation Guide

ManualsBrandsBarMate ManualsElectronicsBARMATE SYSTEM - SAM
31323334353637383940
Chapter 2 Installation
BarMate Installation Guide
27
Installing the battery
To prevent damage during shipping, the SAM is shipped
without its battery in place. The following procedure
describes how to install the battery.
CAUTION:
The Management Centre (Gateway and computer) must
be powered and set-up before power is applied to the
SAM.
To install the battery
1 Remove the four screws from the SAM cover; and then
remove the cover.
2 Remove the two screws that secure the battery bracket.
Figure 13: Battery bracket and screws inside SAM.
3 Insert the 12V Power Up battery (P/NPUBP-7-12 or
equivalent).
4 Connect the red (positive) battery cable to the red fast-
on connector on the battery. Connect the black
Bracket
screws