Installation Guide

Chapter 2 Installation
BarMate Installation Guide
23
5 Use brackets on antenna enclosures to attach RX
antenna enclosures to each end point on the “X”; attach
the TX antenna enclosure at a to-be-determined point
specified by the site survey.
Figure 10: Antenna enclosure and brackets.
►
Note: When the Antenna Array is fully assembled and
mounted, the antenna enclosures should be perpendicular
to the ground with the SMA connector pointing downward
towards the ground.
6 Attach coaxial cable to the SMA jack on the antenna
enclosure.
7 Use cable clamps to dress cables underneath horizontal
tube to centre of Mast, and then run cable down the
groove in the vertical Mast and out to the SAM.
►
Note: Each antenna must have an unobstructed view of
the SRD. If an object, such as a structure or tree, is
between the components it may interrupt wireless
communications (see BarMate site survey).
8 After the SAM is mounted and operational, connect the
antennas in the array to the SAM. See “Installing a SAM”
on page 4.
Bracket
Antenna
Enclosure