Installation Guide

Chapter 2 Installation
14 BarMate Installation Guide
Installing Gateway
Generally, the Gateway will be located next to the
Management Centre PC. Refer to the site survey for the
exact location. Also, the Gateway’s COM antenna should be
mounted before it is connected to the Gateway.
CAUTION:
The Gateway can be damaged if it gets wet. Do not place
liquids on this device or allow liquids to accidentally spill on this
device.
To install Gateway
1 Place the Gateway near the PC to which it will be
connected. It is recommended that the Gateway is
placed in an elevated position with a good line of sight to
at least one SAM.
2 Connect the coaxial cable to the N-Female connector on
the COM Antenna. Connect the other end of the cable to
the TNC connector on the Gateway.
3 Connect one end of the USB cable to the USB port on
the computer. Connect the other end to the USB-B port
on Gateway.
Figure 2: Gateway connections.