ND300-MAN-ONL-02_1903
ATTENTION! Made in China © 2019 Barkan Mounts Ltd. All rights reserved. Specifications and colors are subject to change without prior notice, and may differ slightly from what is shown. Actual product may vary due to constant product enhancement. EN WGP-NW-BNG- ONLINE-1908 Please read the following Caution This mount is intended for use only with the maximum weight as indicated. Using heavier products might cause injury.
EN WARNING! Disregarding the safety and assembly instructions may result in the falling of and/ or damage to your electrical appliance. Opening the package represents your undertaking to closely read and follow the instructions. This mount is not intended for use in public places. For Safety Instructions, warranty and further information, go to: www.barkanmounts.
Page 2 of 7 A B # M L " / mm = Z1 M4 3/4" / 20 x4 x1 Z4 Z5 x6 x2 Z7 Z6 x8 Z10 Z9 x1 Z2 M6 1" / 25 Z3 M8 1" / 25 (6 spare) x30 Z11 (spare) x2 x4 x4 Z8 (1 spare) x3 x2 Z12 (spare) x4 (spare) x2 No.
1A Page 3 of 7 For VESA pattern 400X400mm, move the spacer attached to part B upward as shown. B x2 2 2 Connect parts B to the back of TV, while parts Z5 are below part B. Choose the screw that fits the VESA holes’ diameter. Z1 Z4 Z2 B Z4 Z5 Z3 3 Notice: the VESA pattern might NOT be the screen center. The center of part A will be located on the center of the VESA pattern. Consider the vertical distance between the center of the VESA pattern and the center of the TV.
Page 4 of 7 4 Place part A on the wall, use a stud finder to make sure the 2 holes are not on studs. Level part A on the wall using the finger-saving tool. Mark the 2 holes in part A on the wall with a pencil. A Z7 Z9 5 Place the arrow anchors Z7 in the fingersaving tool. Hammer the anchor into the wall. Please note that the longer tab of the anchor is facing up. Z7 Assemble the wall plate to the wall with the screw and washer.
6 Place the nails parts Z6 in the finger-saving tool. Page 5 of 7 Z6 7 Hammer the nails to the wall through the holes in part A. 8 Make sure the nails are hammered all the way in the wall. It's OK if some nails hit the studs and will not go in all the way.
9 Perform a test by pulling the wall plate downward, not outward. Page 6 of 7 If the wall plate was pulled out, the installation was not preformed properly. Please contact our customer service for further instructions. 82lbs / 37kg 10 Connect the TV to part A: hang the top of parts B on the top of part A, push the bottom of the TV until the bottoms of parts B are hung on the bottom of part A and you hear a click. TV 11 Test the locking mechanism gently.
Page 7 of 7 12 To move the screen sideways, lift the screen slightly and slide it to the wanted side. In order to disconnect, lift the TV up and then pull its bottom away from the wall.
