Specifications

Manual 2100-420
Page 28
FAN BLADE SETTING DIMENSIONS
Any service work requiring removal or adjustment in
the fan and/or motor area will require that the
dimensions in Table 7 be checked and blade adjusted in
or out of the motor shaft accordingly.
1
2
3
4
5
Maximum ESP (inches WC) shown is with 1” thick disposable filter (reduced by .2 for 2” filter).
Rated CFM for ducted applications – required for maximum performance rating. To obtain full CFM on models QH362, QH422,
QH482 and QH602 connect the pink jumper wire (provided) to terminal #G2 and #Y on the low voltage terminal block located in
the circuit breaker box.
Optional CFM – the unit is shipped from the factory set to operate at the optional CFM level shown. This provides lower operating
sound levels for non-ducted, free discharge applications. This reduces system capacity performance by approximately 2% at the
same energy efficiency.
Continuous fan CFM is the total air being circulated during continuous fan mode.
Models QH242 – when operating on 2nd stage heating the indoor air will increase to 1000 CFM.
REFRIGERANT CHARGE
The correct system R-22 charge is shown on the unit
rating plate. Optimum unit cooling performance will
occur with a refrigerant charge resulting in a Super Heat
as shown in Table 8. If correct charge is in doubt,
recover the refrigerant and recharge per the charge on
the unit rating plate.
FIGURE 23
FAN BLADE SETTING
MIS-983
TABLE 7
FAN BLADE DIMENSIONS
LEDOM
ANOISNEMID
)SEHCNI(
342HQ
203HQ
263HQ
224HQ
284HQ
206HQ
057.
057.
057.
057.
057.
057.
TABLE 8
SUPER HEAT AT COMPRESSOR
LEDOM
DETAR
MFC
DOF°59
ERUTAREPMET
DOF°28
ERUTAREPMET
342HQ00881-6161-41
203HQ000181-6171-51
263HQ002181-6161-41
224HQ002112-9181-61
284HQ004152-3242-22
206HQ05519-751-31
NOTE: These units are equipped with a variable speed (ECM) indoor motor that automatically adjust itself to
maintain approximately the same rate of indoor air flow in both heating and cooling, dry and wet coil
conditions and at both 230/208 or 460 volts.
TABLE 9
INDOOR BLOWER PERFORMANCE
ledoM
PSEdetaR
1
PSE.xaM
2
MFCdetaR
3
lanoitpO
MFC
4
suounitnoC
MFC
@MFC
xaM PSE.
342HQ
5
01.5.0008008007
203HQ51.8.000010001019
263HQ51.8.00021000100015711
224HQ51.8.00021000100015711
284HQ51.8.00041001100115711
206HQ02.5.00551052105210041