User manual

CHAPTER 3
Menu System
Technospot
TM
User Manual 27
Set Menu
The Set Parameters menu lets you configure your fixture’s motion, display, lamp, and data source
settings.
To enter the Set menu:
1. Press the MODE/ESC button to enter the first level of the menu system. The display will
show Address and Info as the first two options in the top menu level.
The red star
*
indicates the current option.
2. Using the buttons, scroll to Set.
3. Press the button to select.
Status Options
This menu lets you configure various fixture functions. To set a status option:
1. Navigate to and select the Set menu as shown above.
2. Using the buttons, scroll to Status and press the button to select.
3. Using the buttons, scroll to one of the status options below and press the button
to select.
4. Using the buttons, scroll to the desired setting and press the button to select.
No DMX Mode
This option determines the fixture state after the DMX signal is removed. You can choose from the
following options:
CloseShutter: Closes shutter when DMX is removed
Hold: Holds the current values for all parameters
Auto Program: Reverts to Auto Program Playback
Music Ctrl: Reverts to Music Control Playback
Pan Reverse
This menu option inverts the direction of the pan motor to coordinate movements between
fixtures mounted opposite each other horizontally.
The default setting is Off. Select On to invert the fixture’s Pan motion.
Tilt Reverse
This menu option inverts the direction of the tilt motor to coordinate movements between fixtures
on a link facing each other vertically.
The default setting is Off. Select On to invert the fixture’s Tilt motion.
MODE
/ ESC