User manual

CHAPTER 2
Setup and Configuration
10 Technospot
TM
User Manual
Use the following steps to mount a Technospot fixture on a standard truss:
1. Fix the clamp on the bracket by tightening the M12 screw on the bracket to the hole in the
center of the bracket.
2. Insert the quick-lock fasteners of the first Omega holder into the respective holes on the
bottom of the fixture. Tighten the quick-lock fasteners fully clockwise.
3. Install the second Omega holder.
CAUTION!
Only experienced lighting personnel should attempt to hang a lighting
fixture to an appropriate theatrical truss.
WARNING!
In all cases, a safety cable should also be fixed between the safety cable
mounting point located at the bottom of the fixture base housing and the
truss. Failure to use a safety cable could result in injury or death. High End
Systems supplies the proper safety cables and may be contacted for
replacements if necessary. For more information go to:
www.highend.com/trusshang.
1. Omega-holders
2. Clamp
3. Safety cable