Service manual

80
Setting up the SPI transport stream input
4
Setup and monitoring
◆
Setting up the SPI transport stream input
To set up the SPI input The S
TELLAR
has 2 transport stream inputs.
Do as follows to set up the SPI transport stream input:
1. From the Codec Explorer right-click on the icon representing the transport
stream and select Properties.
2. Click Line Input to be Automatic unless you always want the line input from
a specific line.
The S
TELLAR
automatically selects the active line input signal. The auto-switch-
ing criteria are input loss and transport stream loss. If an autoswitching has
occurred the S
TELLAR
will keep the new line input as long as there is a valid sig-
nal
ROSA automatically displays:
• the input selected by the S
TELLAR
in the Line input field,
• whether or not a Reed Solomon error correction algorithm has been applied to
the input signal in the Format field. “188RSOFF” means that the Reed
Solomon algorithm is not applied. “204RSON” means that the Reed Solomon
algorithm is applied. “204RSOFF” means that the Reed Solomon algorithm is
not applied but there is RS overhead.
3. Click Apply.