Service manual

64
Installing ROSA/C
OPERNICUS
4
Setup and monitoring
◆
Installing ROSA/C
OPERNICUS
System requirements The following table shows the minimum PC requirements for running the S
TELLAR
control software:
Note! If you want to install ROSA/C
OPERNICUS
in a network environment
with several codecs you also need a serial I/O card or an RS-232/RS-
485 converter. Furthermore the TCP/IP protocol must be installed on the
ROSA PC.
Installation procedure Do as follows to install the ROSA/C
OPERNICUS
:
1. Install the ROSA Device Configuration Shell on your PC, or install C
OPER
-
NICUS
on the C
OPERNICUS
serverandROSAontheclientPC.
For further information see the ROSA or the C
OPERNICUS
User Manual.
Item Requirements
PC Pentium based, minimum speed 120 MHz
Operating system MS Windows 95, MS Windows 98 or Windows NT 4.0,
including MS Internet Explorer 4.0 or greater
RAM 32 MB minimum
Mouse Windows compatible
Display SVGA Color monitor, preferably 17"
SVGA graphics card 800 x 600 pixels in 256 colors; 1024x768 and
acceleration recommended
CD ROM drive Yes