Service manual

Chapter 4
61
Setup and monitoring
4
Getting started with ROSA 63
Control modes 63
Installing ROSA/C
OPERNICUS
64
Installing drivers 67
Setting the S
TELLAR
addresses in ROSA/C
OPERNICUS
69
Adding a unit to ROSA 70
Codec-specific user interface 71
General navigation rules 72
Codec explorer hierarchy 73
Setting up the S
TELLAR
76
Before you begin 76
Setting up the network input 77
Setting up the ASI transport stream input 79
Setting up the SPI transport stream input 80
Setting up the V.35 TS input 81
Setting up the descrambling 82
Naming a program 83
Viewing the video output resource 84
Setting up the video output 85
Setting up the video decoding 87
Setting up the inserted VBI 88
Setting up the synchronization of the video output 90
Setting up the AUX, WSS, EDH and VITC output (VBI 1) 92
Enabling the encoder VBI lines (VBI 2) 93
Setting up the IDS and VPS lines (VBI 3) 94
Enabling the teletext 95
Setting up the audio output resource 96
Setting up the analog audio output 97
Setting up the N x 64 kbit/s data output resources 98
Setting up the ASI restamping TS output 99
Setting up the SMPTE 310M output 100
Alarms and messages 101
Alarms and message setup 101
Setting up the general message parameters 103