Service manual

60
Setup example
3
Front panel operation
◆
Setup example
To set up the S
TELLAR
The following example shows how to set up the S
TELLAR
.
To set up the decoding 1. Select input.
Select A/B or Automatic.
2. Select framing if your input is G.703.
3. If necessary set 204RS to On or Off (only applicable for ASI inputs).
4. Select the program to decode.
The S
TELLAR
displays “no PAT available” if there is input loss.
5. Select the wanted Audio PID on the primary audio output.
The audio PID represents the audio program to be decoded.
6. If relevant select the wanted Audio PID on the optional audio output.
The audio PID represents the audio program to be decoded
7. Set the audio interface to analog or digital.
Adjust the gain and set the impedance if the interface is analog.
8. Check the video and audio output.