Service manual

VBI output
53
3
◆
VBI output
Structure When you press the Preset shortcut key and the left arrow key twice the “VBI setup”
menu appears.
Each parameter is described in the following. For instructions on how to edit the
parameters, see Navigating and editing, p. 39.
The menu has the following structure:
VBI teletext Parameters On, Off.
present, not present
Description Enables or disables teletext. “present/not present” indicates
whether teletext is detected in the incoming signal or not.
Teletext B and C are supported.
VBI transparent lines Parameters On, Off
present, not present
Description On enables the transparent VBI lines. Off disables the lines.
“present/not present” are status fields displaying whether or not
transparent VBI lines are detected in the input signal.
Insert VITS field 1 Parameters 625 lines systems: 0 or 6 to 22.
525 lines systems: 0 or 10 to 19
Description Set up the lines where the VITS will be inserted for field one. If
you enter 0 no lines are inserted. For information on the contents
of the lines according to ITU-R Rec. 473-5, see Setting up the
insertedVBI,p.88.
Insert VITS field 2 Parameters 625 lines systems: 0 or 318 to 335.
525 lines systems: 0 or 273 to 282
Description Set up the lines where the VITS will be inserted for field one. If
you enter 0 no lines are inserted. For information on the contents
of the lines according to ITU-R Rec. 473-5, see Setting up the
insertedVBI,p.88.
VBI setup
VBI teletext
<on/Off>, [present/not.]
VBI transparent lines
<Off>, <present/not pr.>
<On>, <present/not pr..>
Insert VITS field 1
Line 1: ___ Line 2: ___
Insert VITS field 2
Line 1: ___ Line 2: ___
99-034