Service manual

ASI output mode (option slot 1)

◆

ASI output mode (option slot 1)

Structure When you press the Program shortcut key and the right arrow key trice the “ASI out-

put mode” menu appears if the ASI output module is installed.

Each parameter is described in the following. For instructions on how to edit the

parameters, see Navigating and editing, p. 39.

The menu has the following structure:

ASI output mode Parameters Packet, Byte

Description Select the ASI output mode “Packet” unless you have specific

requirements. Some non-BARCO decoders specifically require

Packet or Byte mode. Set the mode accordingly.

ASI output format Parameters 188RSOFF, 204RSON, 204RSOFF

Description This setting only takes place in the restamping mode. See below.

“188RSOFF” means that the Reed Solomon algorithm is not

applied. 204RSON means that the Reed Solomon algorithm is

applied. “204RSOFF” means that there is no Reed Solomon

algorithm applied but there is RS overhead.

ASI restamping mode Parameters Transparent, Restamping

Description Select Restamping if your output frequency differs from the input

frequency. Select Transparent if the output frequency is identical

to the network/TS input frequency. Likewise, the output format is

identical to the input format.

ASI output bit rate Parameters 1 to 92 Mbit/s

Description You can only set the output bit rate if Restamping has been

selected. See above. The output bit rate must be equal to or higher

than the net bit rate of the incoming network/TS input.

ASI output mode

ASI restamping mode

ASI output format

<188RSOFF/204RSON...>

ASI output bitrate

__.______ Mbit/s

ASI output mode = Restamping

Option slot 1

ASI output present

00-012