Service manual

Navigating and editing
39
3
◆
Navigating and editing
Introduction This section describes how to navigate through the menus and how to edit the set-
tings.
Navigating There are three different ways of navigating through the menus.
To edit a parameter When you have navigated to the parameter you want to change, use the following
procedure:
1. Press Enter to go into edit mode.
2. Use the cursor keys to change the value.
You do this either by scrolling through a list of possible settings, or by changing
each digit of a number, for example a bit rate. If you have changed a setting and
realize that you do not want to change it anyway – press Esc – and the original
value is restored.
3. Press Enter to confirm the new value and leave the edit mode.
Keys Function
Cursor
With the 4 cursor keys you can move left and right to access
the different main menus. In each menu you can scroll down
(and up) to access the different parameters for the chosen
main menu.
Ifyouwanttogotoanothermenu,youhavetogoupwardsto
the top item and then move left/right again. To do this quicker
you can use one of the following methods.
Shortcut
By using the shortcut keys, you can jump directly from your
current position to the top of the most important menus:
NETWORK, PROGRAM, PRESET, CONFIG, STATUS.
Then you can use the cursor keys to scroll downwards.
Esc key
When you have moved downwards in one of the menus and
you want to go back to the top, you can press the Esc key,
instead of scrolling all the way up again.
User
Not implemented yet.