Service manual

28
Connecting a PC to the codec
2
Installation
◆
Control connectors
◆
Connecting a PC to the codec
You can set up and control the S
TELLAR
by using a PC and the management and con-
trol system ROSA.
Overview The S
TELLAR
can be controlled via a PC in three different ways:
Control Connector Comm. Use
Local Front panel,
local
RS-232 Local setup and control of one S
TELLAR
.
Cable length between the S
TELLAR
and the
PC up to 5 m.
Local Connector
panel,
remote
RS-485 Local setup and control of one S
TELLAR
.
Cable length between the S
TELLAR
and the
PC up to 50 m.
Remote Connector
panel,
remote
RS-485 Permanent monitoring and management of
several S
TELLAR
decoders in a network. The
PC is connected to the Management system
C
OPERNICUS
(industrial computer). Cable
length up to 50 m.