Service manual

26
Connecting the output signals
2
Installation
5. Connect the N x 64 kbit/s data output to the connector marked N x 64 kbit/s
OUT.
To terminate the
reference input
You must terminate the reference input:
1. Connect a T-piece to the reference input connector.
.
2. Connect a terminator to the other end of the T-piece.
3. If you are using a second S
TELLAR
, connect theT-piece at the reference
inputofthesecondS
TELLAR
.
4. Connect the open end of the T-piece of S
TELLAR
1 to the T-piece at the refer-
ence input at S
TELLAR
2.
5. Connect a terminator to the other end of the T-piece at S
TELLAR
2.
T piece
Ref. input connector
Black and burst com-
posite reference input
to a second
decoder
Terminator
or
decoder connector panel
99-038