Service manual

Connecting the output signals

Nx64kbit/sdata

output, pin allocation

The following table shows the connector and the pin allocation for the N x 64 kbit/s

data output.

To connect to the video,

audio and data outputs

1. Connect the cable for the video signal to the connector for SDI or composite

video.

If you have a studio input reference connect the cable to the REF. IN connector.

You need a composite Black and burst input signal and the SDI genlock module

must be installed.

Note! You must terminate the Reference input. The order number for the

terminator is 906565. For further information on termination, see To

terminate the reference input, in Connecting the output signals,

p. 26.

2. Connect the two cables for the analog audio signal to the appropriate con-

nectors in the connector groups AUDIO 1 L and R orAUDIO 2 L and R

3. connect the cable for the digital AES/EBU audio signal to the appropriate

connector AUDIO 1 AES/EBU or AUDIO 2 AES/EBU.

4. Connect the auxiliary data output to the connector marked RS-232 or RS-

422.

The auxiliary data channel which was assigned to the video channel will be

decoded in the decoder.

Connector Pin allocation Output signal

1: Ground

2: Not connected

3: Clk (A) (Output)

4: Data (A) (Output)

5: Indication (A) (Output)

6: Not connected

7: Clk (B) (Output)

8: Data (B) (Output)

9: Indication (B) (Output)

N x 64 kbit/s data output. N

=1,2,3,4,5or6.

Connector type: 9-pin sub-D

female.