Service manual

ROSA messages
123
5
◆
ROSA messages
Before you start Messages from the S
TELLAR
are shown in the C
OPERNICUS
explorer window.
message list The following shows an alphabetical list of the available ROSA messages and their
default status and an explanation to the messages
No. Information Name Enabled Severity Category Explanation/Remedy
25 Audio output error Audio
decoding
error
On Major A There is no valid audio output due to
decoding errors. Check the source and the
condition of the input signal
6 Communication
error
Cmd to
missing
module
Off Information Disable A command was issued for a module that
is not present.
Command
not
supported
Off Information Disable The software of the decoder does not
support this command.
Command
syntax error
Off Information Disable A syntax error is found in a command to
the decoder.
Improper
use of
command
Off Information Disable A module does not support the command,
or the command has been issued to a
module that is not present.
Macro
already
recording
Off Information Disable A macro is already being recorded. Wait
recording another macro unil the present
recording has finished.
Max. macro
size
exceeded
Off Information Disable You have tried to record more than the
maximum 256 characters. Try making the
macro shorter or divide your instructions
into two macros.
Missing
comma
Off Information Disable A comma is missing in a command.
Check the command reference.
Parameter
out of range
Off Information Disable A parameter within a decoder command
exceeds the range specified for the
command.
Unknown
command
keyword
Off Information Disable A keyword in a command is unknown to
the decoder.
Value
truncated
Off Information Disable An input parameter has been truncated.
You may get the actual setting by
reloading the relevant ROSA window or
by a query.
Wrong
parameter
type
Off Information Disable A parameter within a decoder command
has a wrong type.