Service manual

Replacing the DC fuse

121

◆

Replacing the DC fuse

To replace the DC fuse To replace a DC fuse do the following:

1. Turn off the power to the S

TELLAR

Remove the power cord from the S

TELLAR

2. Unscrew the two screws holding the DC filter.

UseaPZ1pozi-drivescrewdriver.

3. Pull out the DC filter.

4. Gently press down the fuse holder and turn it 45 ° counter-clockwise.

Use a flat-bladed screwdriver.

5. Pull out the fuse holder.

6. Remove the blown fuse.

7. Insert the new fuse in the holder.

Caution! For continued protection against risk of fire replace only with same

type and rating of fuse.

8. Reinsert the fuse holder and screw the DC unit into the connector panel.

Fuse holder

98-016