Service manual

100
Setting up the SMPTE 310M output
4
Setup and monitoring
◆
Setting up the SMPTE 310M output
To set up the SMPTE
310M output
When installed with the SMPTE 310M output option the S
TELLAR
can extract the
19.39 Mbit/s SMPTE data from the incoming data stream.
Do as follows to set up the SMPTE 310M output:
1. From the Codec Explorer right-click on the SMPTE 310 output icon and
select Properties.
2. Select Mute if you want the output signal to be muted in case of input loss.
The output is 0 V DC.
3. Select null packets if you want the output signal to contain null packets in
case of input loss.
This may be interesting in an installation phase where you want to make certain
that the electrical throughput from the S
TELLAR
to for example an 8VSB modula-
tor is correct although you do not have an input signal.
4. Click Apply.