User manual

CHAPTER 3
Menu System
SolaSpot LED
TM
User Manual 27
To expand the pan range, scroll from the default option of 540 to 630 and press the button to
select.
Encoders
Encoders maintain the Pan and Tilt position of the fixture, but may need to be disabled to perform
certain test and maintenance procedures. The default setting is On. To disable encoders, select
the Off option.
Pan/Tilt Speed
This options adjusts the maximum movement speed of the pan and tilt parameters. The Speed 1
option is the default normal movement speed. Speed 2, Speed 3, and Speed 4 options are
progressively slower maximum movement speeds.
Mic Sensitivity
You can adjust the input level for the internal microphone by setting this option from 0% –99%.
The Default value is 70%.
Hibernation (Standby Mode)
This menu option determines how the fixture will react in the event of DMX data loss.
Turn Hibernation off to keep the shutter open until shutdown by selecting Off.
Scroll to any value from 01M – 99M to set the number of minutes after data loss before closing
the shutter. The default setting is 15M.
Service Setting
Two options for service setting allow you to set a Service Password or a RDM PID code.
To change the Service Password:
1. Navigate to and select the Set menu as shown on page 26.
2. Using the buttons, scroll to Status and press the button to select.
3. Using the buttons, scroll to Service PIN and press the button to select. The
current password will be displayed. The default is Password = 050.
4. Using the buttons, scroll to a 3-digit number and press the button to select as the
new service password.
Note: A service password must be set before you can enter a six digit RDM PID
number.