User manual

CHAPTER 2
SolaSpot LED Setup and Configuration
10 SolaSpot LED
TM
User Manual
Use the following steps to mount a SolaSpot LED fixture on a standard truss:
1. Fix the clamp on the bracket by tightening the M12 screw on the bracket to the hole in the
center of the bracket.
2. Insert the quick-lock fasteners of the first Omega holder into the respective holes on the
bottom of the fixture. Tighten the quick-lock fasteners fully clockwise.
3. Install the second Omega holder.
4. Pull the safety-rope through the holes on the bottom of the base and over the trussing system
or a sa
fe fixation spot. Insert the end in the carabine and tighten the safety screw.
WARNING!
In all cases a safety cable should also be fixed between the safety cable
mounting holes located at the bottom of the fixture base housing and the
truss. Failure to use a safety cable could result in injury or death. High End
Systems supplies the proper safety cables and may be contacted for
replacements if necessary. For more information go to:
www.highend.com/trusshang
1. Omega-holders
2. Clamp
3. Safety cable
4. Quick-lock fastener