Owner`s manual

4. Barco TRACE Connections
How to Start Image Projection?
1. Press the Standby key on the RCU. (image 4-5)
Tip: Point the RCU towards the Barco TRACE Scree n.
Note: For more information on how to use the RCU see chapter ’Getting Started’ of the Owner’s Manual.
The IR Communication Led on the RCU will light up (for more information see chapter ’Getting Started’ of the Owner’s Manual).
The Barco TRACE Status Led will Light Up Green and Image Projection will be started.
F1
F2
F3
F4
F5
ADJ
EXIT
ENTER
PAUSE
PHASE
TEXT
SHARPN
TINT
COLOR
BRIGHTN
CONTR
TREBLE BALANCE
BASS
VOL
9
0
7
8
5
6
34
1
2
Image 4-5
Standby key on the RCU
4.4.2 Switching to Standby
HowtoSwitchtoStandby?
1. Press the Standby key to switch the Barco TRACE to standby.
4.4.3 Switching Off
HowtoSwitchOff?
1. Unplug the Power Cord from the Wall Outlet.
4.5 Input Connections
Overview
• Source Connections
4.5.1 Source Connections
Source Connection Specifications ?
• The Input has a 5 BNC input terminals for 5 cable input and a DVI plug for DVI input.
• Within the installation mode it is possible to setup the input for 5 cable or DVI (See Owner’s Manual).
• Composite video and super video signals can be connected when an optional decoder is installed.
22
R5976661 BARCO TRACE 04122003