Owner`s manual

3. Installation Guidelines
3.4 Re-adjusting the lamp position in the lamp casing
As the projector has to be opened, this procedure has to be performed by qualified service technician.
Why
With higher run times, the light output of the lamp will decrease, which results in a lower light output on the screen. This light output
decrease can be compensated by readjusting the position of the lamp.
Preparation
1. Push on the top corners of the Front Panel untill a click is heard. (image 3-2, image 3-3)
2. Loosen the Front Panel.
The Front Panel will come to front.
3. Pull off the Front Panel from its Magnet Lock and take it off completly
4. On the side of the inputs, turn the retaining bolt a quarter counter clockwise. (image 3-4, image 3-5)
5. Flip the cover to the left side and take off. (image 3-6)
Image 3-2
Push on the top corners of the Front Panel untill a click is heard
Image 3-3
Push on the top corners of the front panel untill a click is heard
Image 3-4
The bolt is located on the side of the inputs
R5976661 BARCO TRACE 04122003 15