Owner`s manual

8. Service Mode
To adjust the light output in case of a single, stand alone, projector setup set the CLO setting to [SLAVE].
8.8.3 Lamp Mode
The Lamp Mode Setting
The Lamp of the Barco TRACE is always running in Economic Mode.
LAMP
CONSTANT LIGHT OUTPUT [MASTER]
MODE [ECONOMIC]
_________________________________
Serial number : 003706
Article number : R9840740
Run time : 140 hours
Remaining run time : 1360
hours
Number of strikes : 160
Z-axis : 100 units
_________________________________
Select with ↑ or ↓
<ENTER> to toggle
<EXIT> to return
Menu 8-16
8.9 BARCO Logo
8.9.1 Starting Up BARCO Logo
What can be done?
The BARCO Logo can be added to the projected image, in overlay or on a background, on any place on the screen.
How to Start Up the BARCO Logo?
1. Push the cursor key ↑ or ↓ to highlight More. (menu 8-17)
2. Press ENTER to select.
TheotheritemsintheService menu will be displayed.
3. Push the cursor key ↑ or ↓ to highlight Barco Logo. (menu 8-18)
4. Press ENTER to select.
The Barco Logo menu will be displayed. (menu 8-19)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
LAMP
MORE ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-17
SERVICE
BARCO LOGO
PRESET INPUT BALANCE 1
PRESET INPUT BALANCE 2
ELECTRONIC CONVERGENCE
DIAGNOSIS
DYNACOLOR
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-18
BARCO LOGO
STATUS [OFF]
BACKGROUND [OFF]
SHIFT
HOT KEY [OFF]
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 8-19
132 R5976661 BARCO TRACE 04122003